After our previous introduction, I believe you know more or less about the cold regenerator. Today, let's talk about the method of spreading cement.

根據再生層的厚度和預定的再生層的密度及水泥劑量，計算每一再生料需要的水泥用量，并確定水泥擺放的縱橫間距。由于水泥用量很少，為了避免被車輛輪胎的氣流帶走以及天氣突然變化造成的水泥質量損失，水泥的撒布時間越短越好。

According to the thickness of the recycled layer, the predetermined density of the recycled layer and the cement dosage, calculate the cement dosage required for each square meter of recycled material, and determine the vertical and horizontal spacing of cement placement. Due to the small amount of cement, in order to avoid being taken away by the air flow of vehicle tires and the loss of cement quality caused by sudden changes in weather, the shorter the cement spreading time, the better.

冷再生機租賃

Lease of cold regenerator

一般來說，可根據再生機的工作寬度將再生路面劃分為幾幅，再生機施工前一幅時，將水泥撒布在下一幅路面上。水泥撒布完后，原路表面應沒有空白位置，也沒有過分集中現象。

Generally speaking, the recycled pavement can be divided into several sections according to the working width of the recycling machine. When the former section is constructed by the recycling machine, the cement will be distributed on the next section. After the cement is distributed, there shall be no blank position and excessive concentration on the original road surface.

以上就是冷再生機鋪灑水泥的方法，希望對你有所幫助，歡迎來電咨詢！

The above is the method of spreading cement again. I hope it will help you. Welcome to inquire!