2.1 原路面處理針對原路面的鉆心取樣結果及舊路質量狀況評定, 確定合理的處治方式, 對于原路面沉陷路段, 采用級配碎石調平, 使原路面的高程及橫坡滿足設計要求范圍內;對于沉陷嚴重且翻漿路段, 需高度重視, 應挖除原路基淤泥或軟基土等非適用材料, 換填透水性較好和強度較高的天然砂礫或碎礫石, 處理完成后在進行下道工序。

　　2.1 Original pavement treatment: Based on the core sampling results of the original pavement and the evaluation of the quality of the old road, a reasonable treatment method is determined. For the sunken sections of the original pavement, graded crushed stones are used for leveling to ensure that the elevation and cross slope of the original pavement meet the design requirements; For road sections with severe subsidence and frost heave, high attention should be paid to excavating unsuitable materials such as original roadbed silt or soft foundation soil, and replacing them with natural gravel or crushed gravel with good permeability and high strength. After the treatment is completed, the next process can be carried out.

　　2.2 確定水泥撒布量無機結合料穩定材料強度是否滿足實際要求, 與水泥劑量有比較直接的關系, 根據實驗報告數據, 干密度、寬度和深度及水泥劑量, 計算出每平方水泥撒布量, 然后在撒布車電腦上輸入計算用量, 在撒布之前, 試驗人員準備一張1m×1m的薄鐵皮, 撒布車通過后, 稱量鐵皮上的水泥數量, 與撒布車電腦上設置的數據復核, 試驗人員要準確反復對撒布車電腦設置數據與實際撒布量進行復核, 否則此項工作應多次進行, 直到相符為止。同時, 工地試驗室EDTA滴定試驗同步跟進。另外, 每次水泥撒布面不宜太大, 能保證再生機有連續作業面即可, 以防風吹雨淋造成水泥損失。

　　2.2 Determine whether the cement spreading amount and inorganic binder stabilizing material strength meet the actual requirements, which is directly related to the cement dosage. Based on the experimental report data, dry density, width and depth, and cement dosage, calculate the spreading amount per square meter of cement. Then input the calculated dosage on the spreading car computer. Before spreading, the tester prepares a thin iron sheet of 1m × 1m. After the spreading car passes through, weigh the amount of cement on the iron sheet and verify it with the data set on the spreading car computer. The tester should accurately and repeatedly verify the data set on the spreading car computer with the actual spreading amount. Otherwise, this work should be repeated multiple times until it matches. At the same time, the EDTA titration test in the construction site laboratory is being followed up synchronously. In addition, the cement spreading surface should not be too large each time, as long as it can ensure a continuous working surface for the recycling machine to prevent cement loss caused by wind and rain.

　　2.3 控制再生厚度作為冷再生質量控制的關鍵指標, 再生機后安排專人檢查銑刨厚度, 在每刀縱向人工清理出銑刨深度, 再與未再生路面相比較, 對比是否符合設計要求, 對于原路面基層強度較高時, 一次無法達到銑刨深度, 應分二次或多次銑刨, 同時, 實驗人員在檢測壓實度的同時, 檢測再生深度, 確保再生深度符合設計要求。

　　2.3 Controlling the regeneration thickness is a key indicator for cold regeneration quality control. After the regeneration machine, a dedicated person is arranged to inspect the milling thickness, manually clean the milling depth in each longitudinal direction, and compare it with the unreleased road surface to see if it meets the design requirements. For the original road surface with high base strength, if the milling depth cannot be achieved in one time, it should be milled twice or multiple times. At the same time, the experimenters should check the regeneration depth while checking the compaction degree to ensure that the regeneration depth meets the design requirements.

　　2.4 嚴格控制壓實質量再生混合料中一般含有30%~40%的瀝青混合料, 應嚴格控制壓路機的噸位和碾壓遍數, 再生機后應配備1臺不小于26t的單鋼輪壓路機進行初壓, 初壓整平結束后, 再用1臺26t單鋼輪振動壓路機復壓4~6遍, 用1臺30t輪胎壓路機終壓6~8遍。碾壓完成后, 應及時進行壓實度檢測。

　　2.4 Strictly control the compaction quality. Recycled mixtures generally contain 30% to 40% asphalt mixture. The tonnage and number of rolling passes of the roller should be strictly controlled. After the regeneration machine, a single steel wheel roller with a capacity of not less than 26t should be equipped for initial compaction. After the initial compaction and leveling are completed, a 26t single steel wheel vibrating roller should be used for 4-6 times of re compaction, and finally a 30t tire roller should be used for 6-8 times of final compaction. After compaction is completed, timely compaction degree testing should be carried out.

　　2.5 養生養生是水泥穩定無機結合料施工質量控制的關鍵環節, 水泥穩定類基層一般選取氣溫較高季節施工, 水份散失快, 如果施工地點水源較近, 可選擇透水性土工材料覆蓋養生, 灑水車及時補充水份。如果水源地距施工現場較遠, 則考慮使用一布一膜不透水土工布, 在覆蓋之前, 將底基層表面徹底灑濕, 然后覆蓋不透水土工布, 關鍵點就是四周要包裹嚴實。

　　2.5 Health preservation is a key link in the quality control of cement stabilized inorganic binder construction. Cement stabilized base layers are generally constructed in seasons with high temperatures, where water loss is fast. If the construction site is close to a water source, permeable geotechnical materials can be used to cover the health preservation, and water trucks can be used to replenish water in a timely manner. If the water source is far away from the construction site, consider using a one cloth one film impermeable geotextile. Before covering, thoroughly wet the surface of the subgrade layer, and then cover it with impermeable geotextile. The key point is to wrap it tightly around.

　　3 結語冷再生作為一種新興公路施工技術, 可縮短工期、提高作業效率, 減少了環境污染, 節省工程成本, 較適合應用于二、三級公路的底基層或基層, 值得推廣應用。

　　3 Conclusion As a new highway construction technology, cold recycling can shorten the construction period, improve the operation efficiency, reduce environmental pollution, and save project costs. It is more suitable for the subbase or base of Class II and third-class highway, and is worth popularizing.

　　本文由  冷再生機租賃 友情奉獻.更多有關的知識請點擊  http://m.gzmilo.com/   真誠的態度.為您提供為的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is a friendly contribution from Cold Recycling Machine Rental. For more related knowledge, please click http://m.gzmilo.com/ Sincere attitude. We provide you with comprehensive services. We will gradually contribute more relevant knowledge to everyone. Please stay tuned