冷再生機是一種效率高、多用途的施工機械。主要用于瀝青混凝土路面的銑刨以及添加瀝青、水等材料后的舊瀝青路面的再生。也可用于公路、城鄉道路、機場、碼頭、停車場等工程的基層、底層穩定土現場就地拌和作業。那么，冷再生機設備的相關內容您知道多少呢？

Cold regenerator is a kind of construction machinery with high efficiency and multi-purpose. It is mainly used for milling of asphalt concrete pavement and regeneration of old asphalt pavement after adding asphalt, water and other materials. It can also be used for on-site mixing of stabilized soil at the base and bottom of highways, urban and rural roads, airports, wharves, parking lots and other projects. How much do you know about the cold regenerator equipment?

冷再生機一次破碎拌合寬度為2.4米，工作時經常會有一輛水罐車緊跟作業保證拌合用水，拌合過程中按照試驗單所規定的高于平時含水量，除此之外還需要有一輛水罐車需滿水隨時處于待命狀態，一旦跟再生機作業的水罐沒水了，需即刻補上。

The one-time crushing and mixing width of the cold regenerator is 2.4m. During operation, a water tanker will often follow the operation to ensure the mixing water. During the mixing process, the water content specified in the test sheet is higher than the normal water content. In addition, a water tanker needs to be full of water and on standby at any time. Once there is no water in the water tanker working with the regenerator, it needs to be supplemented immediately.

冷再生機的使用需要進行對再生混合料拌，應立即用平地機初步整形。在直線和不設超高的平曲線段，平地機由路肩向路中心進行刮平。很多冷再生機使用的時候，都會面對這點，對路面的整形過程中應及時粗細料離析現象。

The use of the cold regenerator requires mixing the recycled mixture, and the grader shall be used immediately for preliminary shaping. In straight line and flat curve sections without superelevation, the grader shall scrape from the shoulder to the center of the road. Many cold recycling machines will face this when they are used. The segregation of coarse and fine materials should be eliminated in time during the shaping of the pavement.

既由人工配合機械把大塊沒有破碎掉的舊路料掉。冷再生機租賃時候一般行走比較困難，則需先由冷再生機對舊路面層進行銑刨后，在破碎料上再鋪水泥，進行冷再生拌合施工。

The old road materials that have not been broken are removed manually and mechanically. When the cold recycling machine is leased, it is generally difficult to walk, so it is necessary to mill the old pavement layer by the cold recycling machine first, and then pave cement on the crushed materials for cold recycling mixing construction.

此外冷再生機租賃人員認為每天作業后應該設備內的殘余水泥混凝土，使拌刀磨損減小，延長了拌刀使用壽命；整機所有器件的塵土，對潤滑部位加注黃油，使整機潤滑部件的潤滑情況良好，減小了易損件的磨損，從而減少了因磨損而出現的機械故障。

In addition, the residual cement concrete in the equipment shall be removed after daily operation to reduce the wear of the mixing knife and prolong the service life of the mixing knife; Remove the dust from all components of the whole machine and add grease to the lubricating parts to make the lubricating parts of the whole machine well lubricated, reduce the wear of vulnerable parts, and thus reduce the mechanical failure caused by wear.

以上是關于冷再生機設備使用的一些常見事項，大家如有更多的想法和意見歡迎洽談合作，本公司租賃冷再生機等設備，您可以關注我們網站m.gzmilo.com！

The above are some common matters about the use of cold regeneration equipment. If you have more ideas and opinions, you are welcome to negotiate and cooperate. Our company leases cold regeneration machines and other equipment. You can pay attention to our website www.tclqgc com！